ZviZZer Graphene Coat Box 50 ML

ZviZZer Graphene Coat 50ml

ZviZZer Paint Ceramic Graphene coating is one of the most powerful coatings specially developed for optimal and long-lasting protection of car paint. Due to its specific composition, it chemically bonds to your paint to form a hard, glossy protective layer. Once properly applied, the treatment provides long-lasting protection for your bodywork against oxidation, salt, insects and acidic products.

Thanks to ZviZZer's Graphene Ceramic Coat, the clear coat becomes harder and more scratch-resistant (about 60-65%) than conventional paints thanks to the high-quality particles on the surface. Even if you only wash your vehicle by hand, the risk of defects developing over time is likely because current paints are more sensitive. With ZviZZer Graphene Ceramic Coat, these types of defects are minimized or even prevented. Once applied to your vehicle, the Graphene Ceramic Coat provides a strong water-repellent effect, which will strongly prevent dirt from sticking and thus facilitate all your future washes.

The ZviZZer Paint Ceramic Graphene Coating offers unrivalled protection against scratches, chemicals, UV rays and contamination. This means your car will look newer for longer, even in the most challenging conditions. Unlike traditional waxes and sealants, the ZviZZer Paint Ceramic Graphene Coating offers long-lasting protection. A single application can last up to five years, making it a cost-effective long-term solution.

ZviZZer Graphene Coat provides 4 years or 40,000 km protection.

How to use Graphene Coat

We recommend using nitrile gloves to protect your skin! Wash application cloths and all microfiber cloths before use. All accessories must be dry when used.

Application:

• Prepare the surface with CLEAN TOP.
• Wrap the application cloth around the applicator.
• Apply 12-18 drops of the product to the application cloth and apply it quickly and evenly to the surface until a film is visible. Follow this step on small surfaces no larger than 60cm x 60cm.
• Allow the product to evaporate for 1-3 minutes or polish it off immediately.
• Remove any remaining product residue with a microfiber cloth. Start at the edges of the coating and work inward with straight and quick strokes.
• Buff the surface with a clean microfiber cloth. Start at the edges of the coating and work inwards in a circular motion; do not apply too much pressure to the surface during this action.
• Any visible streaks can be buffed out with a microfiber cloth (5 Pack). Check the surface with a light source to ensure quality control of the application.
• If a higher level of protection is required, an additional layer can be applied after 25 minutes. Do not wait longer than 40 minutes to apply this additional coating.

Hazard statements (CLP):
H225 Highly flammable liquid and vapour.
H302 Harmful if swallowed.
H304 May be fatal if swallowed and enters airways.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.

Precautionary statement (CLP):
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P260 Do not breathe dust/fume/gas/mist/vapours/spray.
P280 Wear protective gloves/protective clothing/eye protection/face protection/hearing protection.
P303+P361+P353 IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or shower.
P501 Dispose of waste according to national or regional legislation.