Steering wheel control interface
Retain the original steering wheel remote control functions,
if you trade in your factory radio for an aftermarket radio.
Compare the illustrated connector of the adapter with
that in your car to make sure you have the right one.
Also check if any of the
specified original factory radio is installed in your vehicle!
Steering wheel control adapter Kia
with new white Kia connectors
OEM navigation devices can have different pinouts.
In case of malfunction, please consult our technical service.
Remark:
analog
CAN bus
Connection: ISO / Mini ISO
Vehicles with Blaupunkt OEM device
Vehicles with CAN bus and analog SWI in mini ISO connector C2 pin 10/11/12
Vehicles with Blue and Me module must remain installed
Suitable for the following vehicles:
Fiat Panda (ZAF 169) 10/2003 - 03/2013*.
The following signals are provided:
Imported vehicles or vehicles with different software may be functionally incompatible.
red: +12V ignition terminal 15
orange: +12V lighting terminal 58
purple/white: +12V reverse signal
green: ground GND handbrake signal
Load capacity of all outputs: 100 mA max.
Current requirement greater than 100 mA:
1 relay coil resistance 75 Ohm min.
2 relay coil resistance 150 Ohm min.
Steering wheel remote control
*Vehicles with +12V ignition current terminal 15 and analogue steering wheel remote control in Mini ISO connector C1 Pin 1/2/3:
SWI Fiat Ducato/Multipla/Panda ISO/Mini ISO analog > Item: 42sfa012
Suitable for: Universal
Fiat Panda 2007-2012