Steering wheel control interface
Retain the original steering wheel remote control functions,
if you trade in your factory radio for an aftermarket radio.
Compare the adapter's illustrated connector with
the one in your car to make sure you have the right one.
Also check if any of the
specified original factory radio is installed in your vehicle!
Remark:
analog steering wheel remote control
CAN bus
Connection: 10 pin / 6 pin / 28 pin / 24 pin Toyota connector
Connection: OEM steering wheel remote control > 3.5mm jack / loose cable
Connection: OEM AUX > Cinch(m) red/white
Connection: OEM 360° camera system > Cinch(m) yellow
Vehicles with OEM sound system
Fader function not supported
Vehicle language can only be adjusted if OEM device is installed
DIP switch settings for the aftermarket device manufacturer (see BDA)
Suitable for the following vehicles:
Toyota Highlander (XU50) 2018 - 12/2019
Toyota Landcruiser (J15) 10/2013 - 12/2017
Toyota Landcruiser (J15) 01/2018 - 07/2019
Toyota RAV4 (XA3/XA4) 01/2016 - 12/2018
The following signals are provided:
Re-imported vehicles or vehicles with different software may be incompatible in functions.
red: +12V ignition terminal 15
orange: +12V lighting terminal 58
purple/white: +12V reversing signal
pink: speed signal
green: ground GND handbrake signal
Output load capacity: 250 mA max.
Current requirement greater than 250 mA:
1 relay Coil resistance 75 Ohm min.
2 relays Coil resistance 150 Ohm min.
Steering wheel remote control
OEM sound system
OEM 360° camera system
Suitable for: Toyota Highlander 2018-2019
Toyota Landcruiser 2013-2019
Toyota RAV4 2016-2018